
10
3.2 Connecting Bare Hard Drives
Connecting 3.5” HDDs
Hold the HDD vertically with the SATA connector at the bottom-left and then slowly insert it into the
cradle firmly.
Connecting 2.5” HDDs
Hold the HDD vertically with the SATA connector at the bottom-left and then slowly insert it into the
slot in the cradle firmly.
Warning! When connecting a bare HDD into the Disk 1 or Disk 2 port, please insert the HDD slowly.
Pay attention to the direction that the HDD is facing and the position of the SATA connector. If you insert
the HDD with too much force, it may cause damage to your hard drive or to the miniClone.
Connecting Bare Hard Drives
Comentarios a estos manuales