Kanguru BR-DUPE-S1 Guía de usuario descargar pdf (Pagina 69)

3.18 Copy & Print LightScribe Label (LightScribe models with hard drives only)

The Copy and Print LightScribe Label function combines the Copy (see section 3.4 Copy, p.14) and Print

LightScribe Label (see section 3.17 Print LightScribe Label (LightScribe models only), p.65) into one

process. You will need to flip the disc from the data side to the label side after each duplication round.

In order to operate this function, an image of the Master disc and the LightScribe Label file (.lsi file) have

to be already loaded onto the Duplicator’s hard drive. For more information, please see section 3.16.2

Load Partition, p.60, and section 3.13.15.1 Load Label (LightScribe models with hard drive only), p.51.

Note: Make sure that the USB Connection setting is turned Off. If the USB Connection setting is On then

your duplicator will be unable to access the hard drive.

Preparing... H 247M

Waiting for Blanks

1. From the Main Menu, press the UP or DOWN button to

navigate to Copy & Print LightScribe Label. Press the

ENT button to enter the Copy & Print LightScribe Label

menu.

2. You will see the Choose Partition menu. Press the UP

or DOWN button to navigate to the partition that you

want to copy from and then press the ENT button to

confirm your selection.

3. You will see the Select Label screen. Press the UP or

DOWN button to select a .lsi file and then press the ENT

button to confirm your selection.

4. You will see the Counter screen. For more information

on the Counter, see section 3.2.2 Setting a Job Counter,

p.11.

Once you have set the Counter, any trays that do not

contain discs in them will automatically be ejected. You

will see the Copy Preparation screen.

Counter :

No Counter

Please Select Label

[LSlabel.lsi] 7M

Choose Partition

[TEST.VEF] 4012MB

Kanguru Solutions

14. Copy & Print LightScribe Label

5. Insert the blank printable discs into the Writer drives with the label-side facing up.

After you’ve loaded the drives with discs, close the trays and allow 5 - 10 seconds for the system to detect

them. Once all the discs have been recognized, you will see the Confirmation screen.

Preparing :

7 Disc Detected : Go?

Note: The “7” indicates that there are seven discs recognized

by the Writers. The actual quantity may be different

depending on the number of discs you have inserted.

Copy & Print LightScribe Label

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 88 89

Comentarios a estos manuales

Sin comentarios

Kanguru BR-DUPE-S1 Guía de usuario Pagina 69

Comentarios a estos manuales